我报名......................
峰峰重出江湖了:em01: :em01: :em01:
原帖由 SuVincent 于 2007-5-11 08:18 PM 发表 http://bbs.rcfans.com/images/common/back.gif
是不是这个？
146168
Basic Requirement: MOSFET 3010 x 2 / (1 layer)
Turns: 44T
Endbell: Type M1
Body:
1.) Neo Magnet
2.) Dual Ball bearing with High efficiency cooling case
Perform ...
这个是属于STOCK系列,可以,也可以选择另外一个STOCK系列的马达,
STOCK系列马达是在MINIZ PCB不用加FET的基础上可以最快的改装马达........
The Fastest motor suitable for non-modified PCB, stock miniz.
Battery consumption is similar to Xspeed, but run much faster and more punch power.
Category: Stock turbo or FET upgraded is NOT required.
Armature: Trued armature with Fat commutator provide more efficient for Power.
Light weight armature for FASTER WIND-UP.
Motor can: Provide high efficience cooling effect, long lasting peak performance during a race.
Pre-drilled screw holes support any type motor mount in market.
Special designed End-bell, no need to open the motor casing when cleaning the comm or replacing brushes.
Brush, Both Negative and Positive are (AR-008) Carbon type.
Magnet: Super strong NEO-Magnets, high resistance to demagnetization.
Other: each motor has been tested with motor dyno before packing.
Blue colour 104 cap installed.
RPM
Test Environment: Under 4.8V with 1.8g loading
: 30000 RPM
#AR-030 --- Atomic Ball Bearing Stock Motor --- USD$19.70
http://www.rcatomic.com/main/modules/xoopsgallery/cache/albums/album03/motorview.jpg
:em07: 我都报一个名啦！
频率：AD 4
忘记报band tim~~~am 27.195
比赛的地址：广深线石龙火车站西侧，腾龙新天地商业街
。
广州集合地址：广州市越秀区北京南路68号，北京大厦侧门集中（ENJOYRC楼下）。统一乘车。
时间：2007年5月20号，早上7：00正。
[ 本帖最后由 小仲 于 2007-5-16 04:13 PM 编辑 ]
:em07:
将张推背图放出来先啦，等大家都知道条TRACK系点啊嘛
報名參賽的人數接近20人了，有來自珠三角的朋友，希望本次比賽可以更多人參賽，友誼第一，獎品第2，獎品也異常豐富！
原帖由 stack 于 2007-5-14 04:34 PM 发表 http://bbs.rcfans.com/images/common/back.gif
報名參賽的人數接近20人了，有來自珠三角的朋友，希望本次比賽可以更多人參賽，友誼第一，獎品第2，獎品也異常豐富！
应该是友谊第一，交流第二，奖品第三。
点解吾发动一下港澳同胞,如果这样便是一次省港澳MINI-Z大赛了,哗....
|
|