V16R 说明书

   打好了...


1/10 ELECTRONIC SPEED CONTROLLER

Specifications/Features

   Input Voltage :4.8v-8.4v(4-7cells)

   "NO"resistance : 0.00165 ohm

   Impulse current of MOSFET : 125A

   PWM frequency : 2k-4khz
  
   BEC output voltage : 5.0v(2A)

   Forward/brake/reverse

   Easy setup


Setup and Installation
  
  Turn off the ESC by using the power switch
  
  Connect the motor,battery,and receiver as shown in Fig.1
  
  Switch on the radio
  
  Move the throttle stick to neutral position
  
  Switch on the ESC (The motor will move slightly)

  Press "SET" button and hold until the LED lamp flashes

  Radio throttle stick stays at neutral and press the setup button(the LED Lamp will turn off)

  Move the radio throttle stick to full throttle and then press the setup button (the LED lamp will flash)

  Move the radio throttle stick to full brake and then press the setup button (the LED lamp will turn off)

[em38][em38][em38]大错别濑我

      谢[em50][em50][em49]